I am about to use some leftover heatnbond to make some curtains for DDs room. I lost my packaging. I don't remember the directions and I can't find any online. Anyone help?
First you iron the area, then you put on the heat and bond then you iron that remove the paper and then iron again to bond to whatever. Hope that helps.
I was able to find these detailed instructions for anyone else who may need them:
These are the instructions for Heat N Bond Ultra Hold iron on adhesive.
Often a piece is included in the sample pack for you to try.
Before using Iron - On Adhesive, prewash material without fabric softeners.
1. Preheat iron to wool setting without the steam option.
Place adhesive,paper side up on the back (or wrong side) of material to be bonded.
2. Place and hold iron on paper side for 2 sec. repeat gliding iron to new area and pressing, slighting overlapping previous area until entire surface is bonded. Allow material to cool.
3. Cut to desired size or shape. - Peel off backing
4. Place material, adhesive side down, in desired position on top of project. Press and hold iron for 8-10 sec on each section until entire piece is bonded.
Tips:
DO NOT SEW due to thickness of the adhesive.
To remove try using an adhesive remover or take it to a drycleaner that uses PERC